Yeah it’s a weird thing that I would assume cones from bad slicing, a bad bed or bad mesh leveling. But this can have different reasons too.

Further there are holes in the print, which are a possible problem with extrusion width

Edit: it could also be that it was a bed level change mid print notice how some of it is printed over.

So for me the big bad indicator is basically the upper right corner on the one hand it looks like it was squished to much on the other it looks like an adhesive issue on the last layers of the right side.So a few questions that pop up for me: How does the file look like? Is it maybe wrongly sliced and the last part is in the air? Did you do manual mesh bed leveling? Did you check the bed level from the gantry to the plate with a kaliper to make sure it doesn’t change height between prints (to much)? How old is you nozzle? Is it maybe partially blown?

The problem is not the setup but the administration