mortalic@lemmy.world to 3DPrinting@lemmy.worldEnglish · 1 month agoAny ideas why the top roof warped like it did?lemmy.worldimagemessage-square8linkfedilinkarrow-up145arrow-down11file-text
arrow-up144arrow-down1imageAny ideas why the top roof warped like it did?lemmy.worldmortalic@lemmy.world to 3DPrinting@lemmy.worldEnglish · 1 month agomessage-square8linkfedilinkfile-text
minus-squareMilitias@lemmy.worldlinkfedilinkEnglisharrow-up5·1 month agoNot sure why it would warp there, perhaps infill percentage is too high? If you don’t need the layer lines to be in a specific orientation I’d consider rotating the model back 90° for the reprint, hopefully that should avoid any warping.
minus-squaremortalic@lemmy.worldOPlinkfedilinkEnglisharrow-up1·1 month agoThat does seem to be a good suggestion. I think I’ll do that.
Not sure why it would warp there, perhaps infill percentage is too high?
If you don’t need the layer lines to be in a specific orientation I’d consider rotating the model back 90° for the reprint, hopefully that should avoid any warping.
That does seem to be a good suggestion. I think I’ll do that.