Do you guys have any success with setting up an arr stack with rootless Podman Quadlets? I really like the idea of Quadlets, but I can’t make it work.
Any guide and/or experience sharing would be greatly appreciated.
I have set up a Rocky Linux 10 with Podman 5.4.2 but after downloading the containers the quadlets were crashing.
Shall I continue digging this rabbit hole or shall I switch back to Docker Compose?
Hey, idk if you have a solution for me, but UserNS is not allowed to run together with Pod anymore. Since there is so insanely little information on quadlets, I’m having a hard time starting this up. Did you update yet and found a solution to the problem? (I’m new to podman, at least I got jellyfin somewhat running haha)
Yeah faced that issue a couple of weeks ago as well after updating Podman. It didn’t allow me to set container individual UID/GID mappings or UserNS when running in a pod, so I just took them out of the pod as I couldn’t be bothered and run them as separate containers in the same network. Works just as good.
You just have to make sure to move the PublishPort block from the pod quadlet to the gluetun container (for all the containers which route their traffic through gluetun, i.e. which have ‘Network=container: gluetun’ set). This should solve the problem and still allows you to use UserNS or UID/GID mappings on the containers. No disadvantages so far, you just lose the convenience of stopping/starting all the containers at once through the pod. But I’d rather take this ‘inconvenience’ than troubleshooting for days how to make it work with a pod again.