For monitoring, I’d start with alerts on changes you didn’t make. Save a baseline of listening ports with ss -tlnp and of running containers with docker ps --format '{{.Names}} {{.Image}}', then have a daily cron job compare both against the baseline and push any difference to your phone with ntfy.

Keep the baseline files outside your Docker volumes.

Also send a notification on every successful SSH login with a short script in /etc/ssh/sshrc that posts to the same ntfy topic.

Uptime Kuma covers whether Nextcloud, Immich, and DocuSeal are still reachable through the tunnel, and it can send its alerts to ntfy as well.

Drafted with AI.

https://www.samsung.com/tw/support/computing/about-49-inch-odyssey-oled-g9-display-troubleshooting (OLED G9)

Under the no-picture item it says to check whether the PC supports standard DP 1.4, and if it doesn’t, to set Menu > System > DisplayPort Ver. to 1.2 or 1.1 and reconnect the cable. The menus are probably different between the Neo and OLED models.

Your ‘-1’ comes from the Intel driver, where modeset is an integer and -1 means the driver default. OP has an RTX 5070 Ti, and ‘nvidia_drm’ modeset is a boolean, so ‘/sys/module/nvidia_drm/parameters/modeset’ reads ‘Y’ or ‘N’. Files under ‘/sys/module/*/parameters’ show the value the loaded module is running with.

False. Samsung’s own troubleshooting page for the OLED G9 tells you to go to Menu > System > DisplayPort Ver. > 1.2 or 1.1, then reconnect the cable when the host doesn’t negotiate DP 1.4 cleanly. Users on the Neo G9 report the same OSD option, having dropped the DP setting to 1.2 and 1.1 (OSD) while troubleshooting a no-signal problem. Dropping the version is a standard troubleshooting step. At 1.2 the monitor stops requiring DSC and HBR3, so if link training is the problem the port will often show up as connected even though 240Hz won’t be available.

And nvidia_drm.modeset is a kernel bool parameter, and sysfs renders bools as Y or N.

Set the DisplayPort version in the G9’s on-screen menu to 1.2, replug the cable, and check whether xrandr shows that DP output as connected.

If it still shows disconnected, replug the cable and right after run:

sudo journalctl -k -b | grep -i -E 'nvidia|drm'

Look for link training or EDID errors on that connector.

Also run cat /sys/module/nvidia_drm/parameters/modeset and confirm it returns Y.

Drafted with AI.