No worries thanks for the information!

Good to know, I’ll have to play with it.

Hmmm, that doesn’t sound very encouraging haha. Well I’m gonna try PEI anyway, see if I can keep it flat enough.

I thought too cold caused warping, does too warm cause it as well?

I put the whole apparatus in the fridge for a few hours, hoping it would just pop off.

The edges came up clean, but the very middle was very unhappy. I had some lifting on the corners so I think there was a draft and the plate wasn’t warming equally. Hot spot in the middle trying to keep up maybe? IDK.

I do this too, normally it works a treat.

Somehow I missed all the warning signs and discussion on the subject. I’ll never forget.

Can’t be much worse than a big hunk of glass?

Awesome! I ordered one, I’ll give it a try

Nice! Yeah I’ve loved this glass. I might go back to it, but I’m gonna try PEI for awhile 🤷‍♂️

I googled it, you put down a magnetic sheet first. Sweet, I ordered one

I’ve definitely done that!

How do you keep the plate flat to the bed without magnetics?

I’ve never heard of this, wow, that’s good to know I guess.

Thanks! I did try this, and variations on this, by selecting all and clicking export all 6 items. No dice.

I did just figure out a way though, I made them a union group, which applied the cuts immediately, and they stayed when exported. I’ve never had to do that before. Though admittedly I normally use fusion360. Something is definitely weird though. It should just work without doing that. And in fact it did a few days ago on a different project file.